what type of boiler using in gas and steam power plant

Details


  • Production capacity: 7-70 MW
  • Work pressure: 1.0-1.6 Mpa
  • Applicable fuel: Nature gas, coke oven gas, blast furnace gas, carbon black off-gas, biogas, methanol, etc.
  • Applicable industry: heat suppling, hospital, colleges and universities.


Product introduction

  SZS Series Boiler is double drums, longitudinal arranged, "D" type chamber structure. Furnace is on right side and convection tube bundle is on the left. The body is fixed on the basement by middle and both end flexible supports and make the boiler to expand horizontally to sideways. Around furnace is membrane water cooling tube wall. Furnace and tube bundle is totally separated by the membrane water tube cooling wall at the left side of the furnace. The back part of bundle is sparse shift structure, front part is aligned structure. Smoke from furnace outlet enters re-burning chamber, bundle area, and then from left front part enters spiral fin coil economizer and condenser, finally discharged to atmosphere through chimney.





Safety

  Boiler body high temperature area adopt forced circulation to make sure each part heating area can be cooled down and avoid vaporization;

  Boiler has explosion door and flame detector for safe and reliable operation.

  comb plates are used as the sealing between both sides of boiler and tube bundle all use to avoid leakage of condensate and gas which is caused by refractory concrete sealing.

  air tightness test is done before leaving the factory to ensure no leakage of gas.

environmental protection

  Bigger combustion chamber and Low emission combustion engine to reduce the NOX to 30mg/Nm3

  Smoke duct and smoke outlet has internal insulation to reduce operating noise.

  Combustion chamber use full membrane water cooling wall structure, pressurized firing without smoke mixture.

energy conservation

  Good quality alumina silicate fiber and fire clay insulation is used, boiler body temperature is controlled below 45℃, to reduce heat lost.

  Combustion chamber use narrow distance tube membrane water cooling wall which has good air tightness, and reduce heat lost and increase boiler thermal efficiency.

  Inside of Inspection holes use high-alumina refractory and man hole cover sealing devices, it solved the high temperature of this part by using refractory brick

Convenience

  Thera are manholes on front and back side of both bundle and inspection doors on back side of boiler, which are easy to open for inspection and cleaning inner part.

longer lifespan

  Membrane structure of Front and back wall is used for boiler body, which highly increased their lifespan to over 20 years.

  The key part such as material cutting, rolling, drilling are proceeded by advanced CNC machining process to reduce the assemble stress and extend boiler working lifetime.

  flutter prevention fastener is used for high temperature part convection tube, which avoid bundle tube cracking problem.

  Longitudinal and girth joint adopt advanced automatic submerged-arc welding for good welding quality. All longitudinal and girth joint will have 100% radiographic inspection.

 
Items
Model
SZS7-1.0/115/70-Q SZS10.5-1.0/115/70-Q SZS14-1.25/115/70-Q SZS17.5-1.25/115/70-Q SZS21-1.25/130/70-Q SZS29-1.25/130/70-Q SZS46-1.6/130/70-Q SZS58-1.6/130/70-Q SZS70-1.6/130/70-Q SZS116-1.6/130/70-Q
Rated thermal power(MW) 7.0 10.5 14.0 17.5 21.0 29 46 58 70 116
Rated working pressure(MPa) 1.0 1.0 1.25 1.25 1.25 1.25 1.6 1.6 1.6 1.6
Rated output water temperature(℃) 115 115 115 115 130 130 130 130 130 130
Rated Feeding water temperature(℃) 70 70 70 70 70 70 70 70 70 70
Heating area(㎡) Main body(㎡) 168.0 220.0 245.30 284.40 394.75 428.1 1065.9 1225.7 1408.4 6164.8
Condenser (㎡) 164.0 306.0 527.0 645.1 738.3 990.8 985.3 1292.5 1642.1 1830
Available fuel Natural gas, biogas, coke oven gas, light oil, methanol, biodiesel etc
Gas consumption(Nm³/h) 720 1080 1440 1800 2160 2982 4680 5760 7200 11880
Thermal efficiency(%) >98 >98 >98 >98 >98 >98 >98 >98 >98 >98
MAX.transportation weight(t) 42.0 48.0 52.5 57.5 65.0 72.5 散件12.6 散件13.8 散件16 散件20
MAX. transportation dimension LxWxH(m) 7.87x3.40x3.34 8.85x3.85x3.93 8.51x3.85x3.75 9.31x3.77x3.75 10.10x4.13x4.15 10.90x4.13x4.15 11.00xΦ1.45 11.10xΦ1.46 12.00xΦ1.66 12.50xΦ1.66

CONTACT FORM



An Overview of Combined Cycle Power Plant | EEP Aug 25, 2012 The combined cycle power plant or combined cycle gas turbine, This type of power plant is being installed in increasing numbers It is also possible to use the steam from the boiler for heating purposes so such power The Energy Story Chapter 6: Turbines, Generators Thermal power plants have big boilers that burn a fuel to make heat. Most power plants in California use cleaner-burning natural gas to produce electricity. Steam Boiler | Working principle and Types of Thermal Power Generation Plant or Thermal Power Station There are many different types of boiler utilized for different purposes like running a production unit, loss occurs from steam boiler surrounding wall, defective combustion gas etc. Boiler ( power generation) Wikipedia, the free It has been suggested that this article be merged with Boiler. Type of Steam generator unit used in coal-fired power plants The gas flow was then reversed into a passage or flue beneath the boiler barrel, then divided to return through side Enhanced water/ steam cycle for advanced combined combined cycle power plants are expected to play a major role in the energy mix in A new generation of gas turbines with combined cycle plant efficiencies of .. type of boiler, the conventional separation of steam and boiling water inside a High Efficiency Electric Power Generation MIT Power generating options,including coal fired Rankine cycle steam plants systems, it is important to ensure that the same type of heating value is used. Pulverized coal combustion in Supercritical steam boiler (PC/SC) with steam parameters: .. efficiency gas turbine-steam combined cycles for central power generation. Boilers for steam power plants Alstom Power - Product Catalogue: Boilers for steam power plants Up to 30% of the worlds boilers use Alstom technology, producing a staggering combined output of over 800 GW. Why choose Pulverised coal tower type boiler Gas and oil fired boilers. Electric Generation Using Natural Gas - Sep 20, 2013 Many of the new natural gas fired power plants are known as In these types of generating facilities, there is both a gas turbine and a steam unit, all in to perform other functions, such as powering a boiler or space heating. STEAM TURBINE POWER PLANT ( LECTURE SLIDE 03) | There are two types of air pre heaters for use in steam generators Tubular type power plants is to capture the waste heat from boiler stack gases (flue gas) Thermal power station Wikipedia, the free Natural gas is frequently combusted in gas turbines as well as boilers. The waste heat from a gas turbine, in the form of hot Power plants burning coal, fuel oil, or natural gas are often called fossil-fuel power plants. plants, which do not use co-generation are Combined Cycle Technology Midland Cogeneration The Combined Cycle Power Plant or combined cycle gas turbine, is a gas turbine This type of power plant is being installed in increasing numbers around the to use the steam from the boiler for heating purposes so such power plants can Steam Plant Operation power plants that use steam as an energy source, with the remaining. 10 percent of the The power plant is a facility that transforms various types of energy .. gasfired boiler and a pulverized-coal-fired boiler, each designed for the same POWER4Georgians! Supercritical Power Plants A supercritical power plant uses a boiler/turbine system that operates at 1075 dioxide are captured using wet limestone-gypsum flue gas desulphurization ( FGD). In this case, a drum-type boiler is used because the steam needs to be Type of boilers Fire tube boilers are available for operation with oil, gas or solid fuels. well as steam pressure requirements are high as in the case of process cum power boiler / power boilers. Less tolerance for water quality calls for water treatment plant. Steam- electric power station Wikipedia, the Mohave Generating Station, a 1,580 MW steam-electric power plant near Laughlin, Nevada Natural gas is frequently combusted in gas turbines as well as boilers. The only other types of plants that currently have a significant contribution are This waste heat can be disposed of with cooling water or in cooling towers. Does the fuel types used in a thermal power plant hi, Initial capital costs is highly depends on the type of fuel used for power generation. are some exmples: In fossil fuel power plants, or the fuel oil , gas oil and natural gas, the costs are more. coal-fired boilers are much bigger than gas-fired boiler, Also, with respect to the type of coal used as fuel, the types of mills and Combined Cycle Plant for Power Generation- The most common type of combined cycle power plant utilizes gas turbines and . can be used to preheat all the HRSG exhaust gas boilers with steam to keep Powering A Generation: Generating Electricity The two most common types are Thermal Plants and Kinetic Plants. Thermal Generating Plants. Thermal plants use the energy of heat to make electricity. Water is heated in a boiler until it becomes high-temperature steam. This steam Coal and natural gas are currently cheap in the US, and are being used more often. Steam Turbine Power Plants | Engaged in Power plants that use a steam turbine to produce electricity are categorized There are several different types of fuel that can be used for the boilers in a steam currently used are: fossil fuels (coal, oil, and natural gas), nuclear, and solar. Boilers for steam power plants Alstom Construction (EPC) of new power plants. With operations in 70 countries, advanced oil and gas fired boilers and circulating fluidised for all types of fuels.